General information
Category:
Reports & Report designer
Hi, Thomas-
>there is still something I don't understnad when reading the epl2-doc.
>What is a label-set as the first parameter used by the print command?
>When I read your printing-example you send the number of copies as the
>first parameter and then 1 as default-value.
Well, that took some experimenting to see what would fit our case. We use a continuous roll of labels one-column wide, and I print labels sequentially. In this case Pn,1 = P1,n. However, the way I wanted to control printing the labels, I wanted each set of labels to consist of one label per.
In the example I posted, you could, instead of what I did, print several labels in that block (or set), then when you push to the printer, tell it how many of each label to print in the set. It's a little confusing, I know. And simplicity was one of the reasons I went the way I did. < s > I hope that's somewhat clearer at least.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only