General information
Category:
ActiveX controls in VFP
Just for kicks, I put my multimeter on pins 1 & 2. and Opened my port via the mscomm control. Guess what? The continuance beep fired off. Each time the port opens that circuit is completed. Unfortunately, there is about 10 volts between those two wires all the time, completed circuit or not. I just need the switch, not the voltage.
I've been looking for some off-the shelf item, havent found one yet.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only