General information
Category:
ActiveX controls in VFP
Hi Randy,
Nothing obvious pops out. What is the distance to the conveyor controller? Does the controller provide any feedback when it receives commands (other than movement)? Have you tried a lower baud rate?
>hello everyone, i am having problems with the mscomm control in vfp 7.0.
>the application should be very simple, but for some reason, i cannot get it to be consistent. the program works only about 10 percent of the time. I feel that something has to be wrong with the settings because I can never get the program to work if i send all the data at once. for instance - the concatenated string chr(14) + chr(13) to start the conveyor. There are times when I send the stop command and the belt actually starts or the opposite could occur or nothing might occur. can anyone see a problem with the settings or code. thank you.
>below are the settings and the code.
>
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only