Abedalrahim,

I'm not sure if I'm understanding your question, so post again if this isn't right.

If you open the form in the Form Designer, rightclick and select Data Environment, you can select the view object and press the Delete key to remove the view from the data environment.

If you have any controls bound to that view, you will get errors as the form instantiates, and you'll have to fixup the ControlSource properties.

>I added in view designer in FILTER tab one command for searching, and
>I added this view table to data enviroment in single form.
>the problem is I dont want use USE command to run this view, I used SELECT command to use and it was ok but when i use it again it could not open the message to insert new value (as I said I added a command in view designer).
>do you got the point?.
>
>Note: I dont need to use USE command because I'm using grid in the form
>
>thanks for your time.