Plateforme Level Extreme
Abonnement
Profil corporatif
Produits & Services
Support
Légal
English
Getting Router to drop connection
Message
De
01/12/2003 07:21:27
Hilmar Zonneveld
Independent Consultant
Cochabamba, Bolivie
 
 
À
01/12/2003 03:48:56
Information générale
Forum:
Windows
Catégorie:
Connection modem
Divers
Thread ID:
00854410
Message ID:
00854628
Vues:
19
>Thanks for the response. At the moment I'm not too concerned with individual machines that generate traffic and thus hold the connection - I can deal with those later. As mentioned, at the moment the router keeps the line up even when it is physically detached from the hub that connects it the local LAN. Also, since the traffic is occurring beween the router and the IDSN connection/ISP I don't know if there is any sniffer I can use to monitor this. Again I don't know if this exchange is initiated by the router here or at the ISP or whether this is, in fact, responsible for the problem. I set up the router using the Cisco 'Fast Step' utility and am looking at the resulting setup from the Monitor utility. Maybe I'm going to have to start digging using the console interface. Any further suggestions would be welcome.

As I said, I didn't learn DDR (1) yet, so I don't know the specific configuration commands.

In general terms, the setup utility is fairly limited.

If you don't know much about configuration, perhaps Cisco ConfigMaker can help. This is a free download (you have to fill out a form, indicating how you plan to use it), and it seems to support many Cisco technologies. I don't know whether it specifically supports ISDN & DDR. This would generate the relevant commands, and upload them to the router.

On the other hand, I am taking a quick look at the relevant chapter in the textbook. The following seem to be relevant commands:

  • show dialer: Displays diagnostic information for DDR.
  • dialer idle-timeout: Define timeout for connection. In seconds.
  • dialer-string: Specify phone number to dial.
  • debug dialer: Show information about packets received on a dialer interface. Note: As with all debugging commands, don't forget to issue no debug ... or no debug all when you are finished. Otherwise, the router will have unnecessary work to do.

    There are several other commands listed; I will really have to study the relevant chapter in more detail, to understand the details.


    (1) DDR: Dial on-Demand Routing
    Difference in opinions hath cost many millions of lives: for instance, whether flesh be bread, or bread be flesh; whether whistling be a vice or a virtue; whether it be better to kiss a post, or throw it into the fire... (from Gulliver's Travels)
  • Précédent
    Suivant
    Répondre
    Fil
    Voir

    Click here to load this message in the networking platform