I just noticed on a SEPARATE form, that I see the same behavior. I will check the other property values...

>This looks like a bug in the form designer and is repeatable only in VER 8. Ver7 and 6 are all fine as is FPW2.6
>
>In Tools/Options FORMS tab you can set the max size of a form. I set mine to 1024x768. A different problem occurs when you set the form size limit to "none" (no limit). Seel below
>
>1024x768 Max size
>If you create a new form - Form, New then resize the form to say:
>Height = 750
>Width = 1000
>
>using the property sheet. Now maxmize the form window. Using the scroll bars scroll fully left and fully top( so you can see the 0,0 of the form.
>
>Now try to scroll both right and/or down to access the rightmost/bottommost edge of the form. I find that I am unable to do this.
>
>The only way I can access the right edge is by dragging the form to the left.
>
>But it is impossible to drag the form up enough to see/access the bottom edge.
>
>Another annoying thing about the VFP8 form designer is :
>
>Tools/Options/Forms tab. Set "Max Design Area" to "none"
>
>Now you have access to the edge of large forms but at a price.
>
>With previous versions if the form was taller than the working window(IDE viewport), you were able to smoothly scroll it up/down left/right to access the hidden parts. With VFP8 if you try to do this, the form does NOT scroll but at one point, the whole form scrolls to display the hidden part. If you miss this then you have to start all over again. Also you need to use the "SMALL CHANGE" area of the scroll bar as the "LARGE CHANGE" area just flashes the form past and you have to use the small change to actually get at the edge.
>
>I find this absolutely frustrating and have even resorted to using VFP 7 for GUI design.
>
>Anyone else notice this BUG?