General information
Category:
Reports & Report designer
>Could you put the CAD stuff (whatever it is) into a vfp general field, and then run only the one vfp print job? Using a general field works with some things, but I have no idea about your situation. Won't cost too much work to try it, anyway...
I' ve thought about it, but it doesn't look a good solution, since there are issues with plot styles, zoom of the drawing and so on that don't allow the mentioned approach.
Any other ideas?
TIA
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only