>>Occasionnaly, when a prg contains an error, it seems to stay opened even if I cancel, close all, clear all, set proc to...
>>
>>The only way I found is to close and re-start VFP.
>>
>>Any ideas?
>>
>>TIA
>
>Mario,
>Is the error within a DO WHILE ... ENDDO loop? I had a similar problem in a constant loop where I had CANCEL within the loop. I could not recompile the exe and found that, using Windows NT task manager, there was still a process active for the exe!! I had to end the process to release the exe! I changed the CANCEL to EXIT and it never happened again. There was no button on the task bar but there WAS an entry in the process list.
===
In fact, yes, in this case, my programs stop (because of an error) in the middle of a Do While loop. however, I can't do EXIT, because I'm at the command window ands EXIT can only be used in programs.
This close/reload of VFP is really time consuming.
Any other suggestions?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only