Close the database and set exclusive on, then open and modify
>Any of you seen this before?
>
>I have copied from one database a set of stored procedures to another database. Both databases are in the same project. When I finish changing the new set of stored procedures, I will delete the original database.
>
>At this time, though, when I select the new database (in the project manager), and select Modify, I get an error. I get "Record is out of Range".
>
>Yet, when I open the new database up, from the Project, using Modify, and I right-click the database, I can select "Edit Stored Procedures", and I can edit the stored procedures.
>
>Why am I getting the error message to begin with?
>
>Thanks!
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only