General information
Category:
Coding, syntax & commands
Title:
How to stop FoxUser.*
All,
I've created a simple compress/decompress utility for internal use and I've modified it that it picks up the commandline argument so that it uses the corrects paths. All works fine except after each run (and these compressed files are scattered around a drive) it leaves the FOXUSER.* files in each map.
I don't want that, so I use Set Resource Off in my .prg. No effect.
I set it in my class, no effect. I don't find any Config.fpw (which is good, cause I don't want them)
Somebody any clues on how to get rid of the FOXUSER.* files?
Thanks in advance.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only