General information
Category:
Reports & Report designer
>>Is there a way I can tell programmatically from VFP if a particular printer is dot matrix or not?
>
>I don't think so.
>
>IIRC under Win9x all dot matrix printers used UNIDRV.DLL as one of their drivers. But, this may not hold true if a printer is using a vendor-supplied driver, is running in graphics mode, or is on NT/W2K/WXP.
>
>I can't think of anything reliable you might use.
Too bad. I hope someone is able to come up with some trick.
Thanks,
Alex
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only