General information
Category:
Coding, syntax & commands
I resorted to using a dbf and a procedure file because I was unable to figure out how
to position forms and objects on the screen, otherwise. If I add my form classes and
objects to a project, when I cho0se modify class
then each object or form appears in the upper left hand corner and how do I get to the code to
modify it? But in the form designer, they appear accross the form, as designed but then
the code is only available in pieces in each event? Is there a way to use the class designer,
be able to see the code and modify it, and also see objects in their
relative positions on the screen as in the form designer?
Thanks so very much,
STeve
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only