Hi Gary,
>Depends where you are when you are adding it but from the form :-
m.oCursor = thisform.oCde.addCursor('FreetableName')<
I had used the above line already, but how to you actually open the free table (it's in a special folder), set it's index, etc.?
I assume I would not do these through just native VFP commands... am I correct?
Thanks again. Hope all is going well with you.
Mel Cummings
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only