General information
Category:
Coding, syntax & commands
Hi,
At the start of a program I have Set Safe Off ; however,
when I run this program from the command line, set safe off only takes effect every other
time. So, if I take a break, say 20 minutes, then run the prg,
messages come up "the file exists, ... " But if I cancel then run the program again, set safe
off takes effect. Can't figure out why it does not work every time. VFP 8.0
Thanks
Steve Elster
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only