Hi Craig,

Thanks for the reply. Your suggestion works just fine when I only have one record; however, if I have more than one record, I get goofy results such as duplicate reports, etc.

Still working on it!

Thanks,

TFISHER

>Make report 2 a subreport of report 1. You'll need to experiment a bit with which report 1 band needs to host the subreport.
>
>
>>Hello,
>>
>>I am going to try this again since I haven't been able to figure it out yet!
>>
>>I am using Crystal 9 Developer with SP2 installed.
>>
>>I have two separate reports -- they are form reports. Each report must fit on one side of an 8 1/2 X 11 piece of paper. Most of my clients print one form, turn the paper over and print the other form on the other side of the paper.
>>
>>I have one client that wants to print on a duplex printer, i.e., print both forms on a single piece of paper, letting the printer turn the paper over. This is all well and good, except I can not figure out how to put both of the separate reports on one report so the client can preview both reports, then print using the duplex printer feature.
>>
>>Any help would be appreciated!