General information
Category:
Forms & Form designer
Title:
Invalid or missing Form memo file error (sometimes)
I have a VFP 6.0 form that has been in use since 2001. Last month I began installing a series of changes. The form has no data environment and opens and closes free tables as needed. Since I began making these changes, I have been getting intermittent error messages when I attempt to save the form. The error is always the same... the memo file for MYFILE.SCX is invalid or missing.
If the memo file (MYFILE.SCT) were truly missing, I don't believe VFP would even allow me to open the form. When I get this error, I open Win Explorer and check to make sure the sct file is indeed there, and it is. After I get this message, if I attempt to save it again, I get a File Not Open error. Eventually, VFP gets corrupt and I must crash out of it.
I've tried PACK MEMO, I've even tried copying the form table to a new one. It makes no difference if I've actually made any changes when I attempt to save. If I click on the Save button, without making any changes, mutiple times, I will eventually get the error.
I've copied just the form (without the project) to a different computer with another installation of VFP and get the same results.
The project compiles fine and runs fine, it just has a problem when attempting to save this form.
Any suggestions?
Thanks!
Dick
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only