General information
Category:
Reports & Report designer
----
I tried setting the OneToMany to .T. for boht of the relationships but that didn't work.
----
Don, this property is literally the same thing as SET SKIP. As a matter of fact, if you test SET("SKIP") during the run of a report, and if you have used these properties rather than explicitly having SET SKIP, then you will see the results in SET("SKIP"), just as if you *had* explicitly SET SKIP.
So if it "didn't work", then something else is wrong.
Typically, this would be one of a couple of different possibilities:
1) You do not have the appropriate workarea/alias selected, so the one-to-many relationships aren't going to take effect
2) You are not in the data session you think you are
... those are some "usual suspects" <s>.
>L<
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only