General information
Category:
Visual FoxPro Beta
Fabio,
Could be a doc error. The help says in the conversion table that the vertical axis respresents the source data type and the horizontal the target. However, what I see appears to indicate that it's the reverse. In using the horizontal axis as the source, the indication I see is that that it's only partially supported with possible data loss.
George,
I'm sure VFP doc is correct:
Check M -> C and C -> M casting.
But even if the Documentation was mistaken,
to me does not interest, the CAST function is mistaken.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only