Hi Scott,

Not sure what the fix is for your problem, but I too had a lot of trouble with the VFP6 Setup Wizard. The biggest thing I found was that it was simply not very flexible. I don't recall ever having the problem you described, but I did find a couple of alternatives that I liked a whole lot better. InstallShield Express and InstallShield are two packages I looked at. Both of these were a lot better than the wizard, but I found them to be more difficult to use and more expensive than Wise Solution's InstallMaker (now called Wise Installation System 9 Standard). InstallMaker was really super easy to use and quite flexible. I think it was about $300 at the time we were working in VFP6 and it had built in support for VFP6 (just check a box and the VFP6 runtimes were included in your setup). The newer Wise Installation System is about $450.00. Also, if you have a copy of VFP 8, the included limited edition InstallShield is quite good and is included in VFP8 for no additional cost (FREE!). Any way, I'd suggest looking at alternatives.

Good Luck!

-Don


>Greetings!
>
>I am tyring to use the Setup Wizard in VFP6 for a project which uses several ActiveX controls which are installed and registered on my development machine.
>
>At Step 2 when I check the box to include ActiveX controls, a status box appears stating that my registry is being searched for available classes. As soon as this status message reports 100% complete, the following error message is reported: 'Error# 202 in getactivex(0): invalid path or filename'.
>
>When I click 'OK', a grid appears from which to select controls. I select the controls I want, but then have only three choices to continue: 'Help', 'Close' or 'Cancel'. Selecting either close or cancel will end the wizard.
>
>Any ideas how to fix or get around this problem would be welcome.
>
>Thanks!