Information générale
Titre:
Using RUN command in VFP
When using the RUN command from VFP executing a
"net send" I get a failure or a error that the message is too long even though the message being sent is rather short in length. If the message is over 62 characters the message fails, otherwise it works. If however I go to a command prompt and run the same message directly rather than executing the RUN command from within VFP I can send a message of considerably greater length. I have gone as high as 240 characters with no problem.
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement