General information
Category:
Coding, syntax & commands
I applied the following command under foxpro for dos
set print to com1 , 9600, N, 8, 1, H, RL
It is ok, not showing any error but after that I apply the following and it gives me an erro like:
run echo>com1 Dhs.10
Pl. note that when I apply this command on 'C' drive it show the amount (Dhs.10), How can I patch up this problem ?
Thanks/Regards - Saif
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only