Hi ALL!
I made a program that execute, in the appropiate line, this command:
Modify Report Filename.frx In SCREENThe program show me the report designer and i can modify my report, but when i try to view the result using preview button my program close itself without any message.
This behavior is not present if i run my program from VFP (not compiled) or if i write this line before the Modify Report:
SET REPORTBEHAVIOR 80Is This a Bug or is another my mistake ?
Thanx to all in Advance!
bye, Emanuele!
In the beginning the Universe was created.
This has made a lot of people very angry and been widely regarded as a bad move.
