General information
Category:
Source Safe Control
> Are your files marked as read-only? When we add a file to SourceSafe it marks them as > read-only and when you check them out it changes the attrib on the file.
>Thanks for your comments.
>No, I can modify the file but not save it. I always get File Access Denied. Renaming >the file and any modifications are saved. It is as if "VSS" has the file open for >exclusive use. Any other advice would be welcome.
Found the problem. It was not the prg being denied access but the .fxp and/or the .bak files. Their attributes had also been changed to read-only, so when I tried to save the changes, VFP could not back-up or compile the file. Ohhhh but of course, if only it had become obvious earlier in the day.
Thanks Chuck, read-only was the issue. Can modify, save and smile again
Gordon
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only