General information
Category:
Installation, Setup and Configuration
Title:
Distributing VFP Commands!
Hi every body,
I am using VFP 6 (service pack 5). I run VFP commands in a form in a project. It worked fine before. Recently users install new version of my program on their computers. This time if they run a command in this form, it gives them the following error:
“Feature not available”
Does any body have any thought on this?
Thank you,
Ali
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only