>Giedrius -
>
>When I'm editing report and changing size of (for example) rectangle using SHIFT and left/up/down/right arrows, I see that rectangle's height or width is changing by 0.03 (sometimes by 0.02).
>Is it possible to set it to 0.01 or somehow set exact height or width of rectangle?
>
>Interesting... For me it does use roughly 0.01". This should be because the SHIFT actually tweaks the object by increments of pixels, which in 96 DPI would be 0.0104"
>
>You're using a measurement unit of Centemetres, aren't you? <grin>. Yeah, 1 pixel will give you an increment of about 0.03cm.
>
>Does this answer your question?
>
>- Colin

Yeah, I'm using centemeters...
It seems You are right...

The problem which I sometimes is getting is:
- I'm printing to PDF converter from frx report
- in PDF file I see that some lines are thicker than in frx report. I assume that two rectangle's borders is covering each other in frx report, while in PDF file - not, so I'm getting two lines (borders of rectangles) nearby, but not covered.
- I assuming that this is because those 0.03 centemeters limitation...