General information
Category:
Reports & Report designer
Title:
Field show **** in report
Environment versions
Network:
Windows 2003 Server
I have written a rather simple program that creates three data sets - each using the same report. The first and third data set work fine but the second set of data shows *** in the final total field. The format is set high enough so the number of digits to show is not a problem.
However if I suspend the program after I run the second set of data and then open the report in the report writer, the *** disappear and the correct total is displayed and the report looks fine. When I resume the program the third report prints fine.
Since this is an adhoc report due today, I am using the suspend to print the second report and am printing the other two via the program.
Anyone have any ideas as to what is happening?
Gaylen
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only