>I have written a rather simple program that creates three data sets - each using the same report. The first and third data set work fine but the second set of data shows *** in the final total field. The format is set high enough so the number of digits to show is not a problem.
>
>However if I suspend the program after I run the second set of data and then open the report in the report writer, the *** disappear and the correct total is displayed and the report looks fine. When I resume the program the third report prints fine.
>
>Since this is an adhoc report due today, I am using the suspend to print the second report and am printing the other two via the program.
>
>Anyone have any ideas as to what is happening?
>
>
>Gaylen
Gaylen
Is the totals in the 3rd report higher than in the previous? MAybe your report field isn't actually wide enough, despite the format, to take the bigger number.
Terry
- Whoever said that women are the weaker sex never tried to wrest the bedclothes off one in the middle of the night
- Worry is the interest you pay, in advance, for a loan that you may never need to take out.