Hi Marcus,
You are a lot further along than I on this. But I found this in my HP PCL5 Book. Apparently you must issue the command to enable macro for automatic overlay
ESC &f4X
Hope this helps. I'm watching this thread with much interest. Been looking for software that will convert a scanned form to a macro. Ed pointed me to "Inform" which I have not located yet. Possiblly it is Novell Informs.
Ken
>
>Okay, I lied. Thanks for the PCL tip. I appear to be doing exactly what you say, but here's what happens when I print a one page report (no prompt): A page with my overlay prints out, then a page with my data (no image) prints out. Any ideas why this might happen? You've been a tremendous help. Thanks again.
>
>Marcus.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only