General information
Category:
Reports & Report designer
>This is a classic problem, with a classic solution: you just can´t do it with variables. You need to calculate, *before* you list anything, the grand total, so it will be available for calculating percentages.
>
>HTH!
Thanks for the reply, Federico
Sorry about the rookie type questions but if I calculate the percentage values before I run my report, how do I pass the values to my report before it runs.... with the 'with' command like I do in a procedure as in do 'something' with perc1,perc2,perc3 etc. ?
thanks for your time !
Don
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only