General information
Category:
Reports & Report designer
Hi,
I have a frx-based report where I would like to create a grid using horizontal and vertical lines. I have set-up column separators across the width of the table, each vertical line starting at the header horizontal line, going through the detail band, and connecting with a horizontal line in the group footer.
All looks good at design-time, however when it comes to run-time all the vertical lines end well-below the horizontal footer line. Any idea how I can overcome this problem?
Any help would be appreciated.
Alan
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only