>Hi,
>
>I have a frx-based report where I would like to create a grid using horizontal and vertical lines. I have set-up column separators across the width of the table, each vertical line starting at the header horizontal line, going through the detail band, and connecting with a horizontal line in the group footer.
>
>All looks good at design-time, however when it comes to run-time all the vertical lines end well-below the horizontal footer line. Any idea how I can overcome this problem?
>
>Any help would be appreciated.
>
>Alan
Alan,
Do you have some complex logic in your report with PRINT WHEN conditions? Cathy Pountney suggested for a slightly different problem to change FRX directly to make just one pixel + in header and footer, if I recall correctly.
Re: Report Formating Thread #
1254084 Message #
1254225
If it's not broken, fix it until it is.
My Blog