General information
Category:
Reports & Report designer
>>It needs to have vertical lines drawn at certain
>>points that *must* extend from the
>>header, through every detail line *whether or not
>>there is any data in it*, and
>>into the footer. [...]
>
>Just draw a line(or rectangle) from header to
>footer.
That *does* make the line print *in* the header, detail, and footer
bands of the report, but it doesn't *stretch* the line. For instance,
if I draw a 1 inch long line, the line will start in the header and
print for 1 inch down the page and stop. I can't seem to access
the "Stretch with band" property after drawing the line through
multiple bands.
Let's say I want the header at the top of the page, the footer at the
bottom, and detail lines and blank space in between. How can I get the
vertical line to be printed *continuously* from the header, through
the detail lines and blank space (where there would be detail lines),
and into the footer?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only