>I am trying to install a scsi scanner (old legacy machine).
>
>I have asked windows to find the new device, it installs the drivers, but there is no communication between scanner and computer. When I go to the control panel and check the system, the device installed (the scsi adaptec drivers) has a little red cross and the notice says "device disabled (code 20)" [or it may be 22 I cannot remenber as the computer is at another location]
>
>I have spent many hours going over the same proceedure without any luck. I have also tried switching jumpers all about. How can I enable it?
>
>Thank you for any help.
>Regards,
>Stilman Davis
Is this because of a resource conflict? You may have to go thru the old troubleshooting procedure of removing all other unnecessary cards from the system and see if the thing works, then, extrapolate from there. HTH, CWH.
Chuck Henry