General information
Category:
Reports & Report designer
>Ok here is my solution. For MY problem. I made my pdf printer the default printer from windows. I then checked save printer environment in my report and saved and compiled the application. I then reset the default printer back to the laser printer from windows. Now it prints correctly.
>The save printer environment was not checked before. But it is working now so I am happy.
>
>It seems to me if you tell it in code to use a certain printer then that is what it should do. ??
>
>Randy
In my experience if after an update to another version of software results in situation where the setting appears to be correct, but the behavior isn't -- one of the ways to "fix" the problem is to change the setting to something else, save and close the file, then re-open it and select the desired setting and then save again. Basically the state change will trigger code that will make sure that what is stored in the file fully matches what is displayed on the configuration screen. As an extra measure I also wave a dead chicken over the monitor.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only