General information
Category:
Reports & Report designer
Jim,
the thing with the dot matrix paper length may be a hardware detection of the page length. Some Dot matrix machines I dealt with in the past had the as a configuration option. In most cases you could send an initialization string to the printer to turn that off. In some cases it had a hardware switch to be adjusted.
Hope that helps.
Rick
-----------------------
>I have an app that prints reports to a dot matrix with custom size form-fed reports. I designed the reports on my machine at home where I only have a laser printer. At the customer site I have setup the Dot Matrix to use a Custom size layout, but it still wants to feed the next form through the printer halfway (thinking it's 11 inches). Do I need to remove the printer driver info (DEVICE=HPLaser Jet, PAPERSIZE=1) from the .FRX as it is referring to my HP laserjet?
>
>The printer font quality gets reset as well every time I print. I want it to be draft quality but it prints NLQ. Does this have to do with the 'YResolution=300' setting in the .FRX expression field? If not, what else could reset the print quality? When I run an old DBase report to this same printer it doesn't reset the print quality so it must be in my app.
>
>Thanks in advance
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only