>>I have sent out about 200 copies of my application, and only 1 is having this problem. When they attempt to run the .exe, they immediately get Fatal Error C0000005. I had them try to run another .exe that simply copies files, and does some maintenance, but it gets the same error. They are running Windows98, and I am using VFP6 with all the service packs installed. I even tried loading DCOM98, but it made no difference. I have no _screen commands after the READ EVENTS statement, and in fact the seconds EXE doesn't even have a READ EVENTS. I also issue a ON SHUTDOWN DO myShutdown, and run no SQL statements during the startup program. I know these are common causes of this nasty error. Any Ideas??? Thanks for any feedback.
>>
>
>DCOM isn't likely to be a cause here; I'd suspect that either some of the runtime files are corrupted, or there's a problem with virtual memory (lots of possible causes).
>
>If they haven't tried yet, have them uninstall the VFP6 runtime files (you can do this from a Setup Wizard install by rerunning it interactively, or if you have been using the current Setup Wizard stuff from Microsoft's Web page, the wizard-created install should have created an uninstall/reinstall entry for your application in the Add/Remove Program Control Panel applet) and install them fresh.
>
>The VS Service packs did not contain the Setup Wizard updates; if you didn't download them from Microsoft's site in addition to the Service Packs, you don't have them.
>
>
Thanks Ed,
I have tried uninstalling and re-installing. I also have all the downloads for VFP6 from the MS site including the setup wizard. When you say virtual memory could be causing this, should I be looking at harddisk problems, or do you think re-installing Window98 would help?
thanks again,
Marcus.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only