General information
Category:
Coding, syntax & commands
Title:
Operator/Operand Type Mismatch on 'Select 0'
and if I replace "0" with the name of an open table - the same complaint! Yet as soon as I run the same command from the command window - no problemo...
Fortunately it only happens in one place in the code - the first line of a procedure. So it must reflect some bizarre memory problem presumably caused by something I've just run. Nothing obvious leaping out at me yet.
Anyone ever seen anything like it?
Harry
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only