General information
Category:
Forms & Form designer
Thanks for the offer, John. After some further investigation, I have tracked the problem down. I now know when and where it's happening, I just don't know why or what to do to correct it.
The form I'm working on stores patient information. I have two stored procedures that are simple encryption and decryption routines that I use on patient names and SSNs. On the first page of the form, I have a grid that lists the patients. The problem comes when I set a column's control source to, for example, decrypt(clastname) rather than just clastname. I have done this on another form that is working just fine. I just can't get it to work on this one. Any ideas or suggestions on what to check or try next?
TIA,
Criss
>Hi Criss --
>
>It's been noted that some controls look funky if the font size is too large but never a crap-out because of it, AFAIK. Zip up what you have and send to me and we'll figure it out.
>
>>
>>I've created a form with two tables and a parameterized view. Didn't think that I did anything unusual. However, when I try to run the form (do form myform) I get the error "Error loading file - Font Size - record number 14. Browse table is closed." Anybody have a clue as to where I should start looking for the problem? I'm using VFP3.0b.
>>
>>Thanks in advance!
>>Criss
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only