Hi Mark,
Yes, that's what I do now. I was just curious if anyone had experiences the same problems and had found a solution rather than a workaround.
Appreciate the response.
JME
>Don't use STEP ON. Go to the line of code, right-click and click on SET BREAKPOINT. You can also use the ASSERT command [see VFP help and use with SET ASSERTS ON command].
>
>
>>Much to my surprise, most C5 errors seem to occur when I put a "set step on" command in code to initiate a trace. The error occurs on the next line in code following the "set step on".
>>
>>(1) Does anyone know of a means of preventing VFP sessions from hanging when a C5 error occurs, and
>>
>>(2) Does anyone know of a way of invoking the debugger without risking a C5 error?
>>
>>Any assistance would be greatly appreciated.
>>
>>Many thanks.
Jim Edgar
Jurix Data Corporation
jmedgar@yahoo.comNo trees were destroyed in sending this message. However, a large number of electrons were diverted from their ordinary activities and terribly inconvenienced.