Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
C0000005 Errors with Debug
Message
 
 
To
07/04/2000 17:16:24
General information
Forum:
Visual FoxPro
Category:
Other
Miscellaneous
Thread ID:
00357020
Message ID:
00357317
Views:
15
Hi,
You may have a corrupt configuration in your debug enviroment. From the Command window, issue a CLEAR DEBUG. That will return the debug environment to the default settings. You will then have to open and configure the windows back to your settings.

HTH.

>Hi Mark,
>
>Yes, that's what I do now. I was just curious if anyone had experiences the same problems and had found a solution rather than a workaround.
>
>Appreciate the response.
>
>JME
>
>>Don't use STEP ON. Go to the line of code, right-click and click on SET BREAKPOINT. You can also use the ASSERT command [see VFP help and use with SET ASSERTS ON command].
>>
>>
>>>Much to my surprise, most C5 errors seem to occur when I put a "set step on" command in code to initiate a trace. The error occurs on the next line in code following the "set step on".
>>>
>>>(1) Does anyone know of a means of preventing VFP sessions from hanging when a C5 error occurs, and
>>>
>>>(2) Does anyone know of a way of invoking the debugger without risking a C5 error?
>>>
>>>Any assistance would be greatly appreciated.
>>>
>>>Many thanks.
Larry Miller
MCSD
LWMiller3@verizon.net

Accumulate learning by study, understand what you learn by questioning. -- Mingjiao
Previous
Next
Reply
Map
View

Click here to load this message in the networking platform