Walter Meester
HoogkarspelNetherlands
General information
Category:
Reports & Report designer
Thanks for your reply.
You are right I have more than one issue. What I am trying to do is ... eliminate the need for our users to exit our VFP application and then run any of a series of compiled Crystal Reports. I eventually want to be able to have a VFP front end screen for the reports that captures the parameters and then passed them on to the report.
I was able to make a report appear but I was not able to accept and pass the parameters. I was thinking that part of the problem may be with the OBDC connection since I could make the report ask for parameters but even when I put them in the data did not change in the report.
Anyway I tried the code you sent and I now get an OLE error.
Where did you find the example? I have CR-8 and there seems to be very little outside of samples for VB.
Thanks again.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only