General information
Category:
Third party products
Hi Bill,
Me Again <g>. I have a few queries about Foxfire.
1. I created a preference set and imported all the desired tables using the Wizard, but I didn't create any table relationships at that time. At a later stage I went into the Relationship Editor from the Systems Administrator and kept getting a "LONODE is not an object" error when trying to save my first relationship. I managed to get around the error by opening the ????JOIN table and creating my first relationship manually. It worked fine after that. I can Email you a load of screen dumps for this problem if need be.
2. I was working in a preference set whose data directory is K:\DEMOSYS\DATA. I then created a new preference set for K:\LIVESYS\DATA. When I ran a report in the LIVESYS preference set it kept giving me data from the DEMOSYS tables. I couldn't figure out why this was happening, my directories were set up fine in the preference set. I then discovered that the 'SEARCH PATH FOR USER FILES' was being carried over from a previous preference that I'd been in. My preference set for LIVESYS has K:\DEMOSYS\DATA;K:\LIVESYS\DATA in the search path. I removed the K:\DEMOSYS\DATA part and it now works ok.
3. When running a report to a spreadsheet and a large amount of data is extracted Foxfire appears to hang, but hasn't hung, it's just taking a long time. Is it possible to have a Progress Bar so that the user knows what is happening?
Thanks,
Gavin...
P.S. I hope that you don't have a Voodoo Doll of me in your office, otherwise it would be covered in pins by now <g>.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only