General information
Title:
VFP 3.0 config.fpw problems
I am having problems using my config.fpw file. When I start, VFP runs through my config file as if it were a prg file.
Each line in the file, I get a variable {whatever I am setting to} not found error.,ie; EXCLUSIVE=OFF.
This has been an ongoing problem I have had. I had worked around it before by using the standard SET command syntax in the file,ie; SET EXCLUSIVE OFF. After doing this workaround, I began receiving "No Parameter Statement is Found.". Is there something I am missing?
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only