General information
Category:
ActiveX controls in VFP
Hi Yogi,
>I then installed VFP 6 and found that the CREATE command worked, as did my run-time application. I then uninstalled VFP 6 and found that the run-time application and the CREATE command still worked.
Did you distribute your "run-time application" via a setup program? If no, you need to. If yes, was the setup program generated with the VFP setup wizard? If yes, did you remember to distribute the ITC ActiveX control?
Jon
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only