General information
Category:
Coding, syntax & commands
Could you post a code line where you get those error message?
(Just in case, you can use on error routine, or debug the application.)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>Previous message below
Hello Yuri,
Thanks! That syntax compiles OK. When executing the program I get and error "...cannot move focus to the control because it's invisible, not enabled, or of a type that does not accept focus." This happens whether or not I have .visible=.T.
I'm in a VFP 6.0 Grid that whose record points to the .doc that I want to run the macro against in M$ Word 2000.
Any more wonderful suggestions that would resolve this? TIA.
Thankfully,
Paige
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only