Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
Problems with MSComm control
Message
 
 
To
08/06/2001 12:32:37
General information
Forum:
Visual FoxPro
Category:
ActiveX controls in VFP
Miscellaneous
Thread ID:
00515479
Message ID:
00517209
Views:
19
>Hi Len,
>
>Yeah, I thought that might be the case. I tried a crossover from COM1: to COM2: and ran 2 instances of Procomm. Also took a single port over to an Epson LQ-850 in Hex Dump mode. In all cases, all I see is hex(01 41 0D) for his F2 sequence. All function keys in Wyse-50 emulation exhibit the exact same behavior in Procomm. I am beginning to think these default function keys are meant to be terminal to host only, not to drive the terminal.

That's what I was beginning to think too, but then wyse shft+F16 ( CHR( 01 ) + CHR( 111 ) + CHR( 13 ) or HEX 01 6F 0D ) does work. I'm lost on this one.
John
Previous
Next
Reply
Map
View

Click here to load this message in the networking platform