General information
Category:
ActiveX controls in VFP
>>Hi Len,
>>
>>Yeah, I thought that might be the case. I tried a crossover from COM1: to COM2: and ran 2 instances of Procomm. Also took a single port over to an Epson LQ-850 in Hex Dump mode. In all cases, all I see is hex(01 41 0D) for his F2 sequence. All function keys in Wyse-50 emulation exhibit the exact same behavior in Procomm. I am beginning to think these default function keys are meant to be terminal to host only, not to drive the terminal.
>
>That's what I was beginning to think too, but then wyse shft+F16 ( CHR( 01 ) + CHR( 111 ) + CHR( 13 ) or HEX 01 6F 0D ) does work. I'm lost on this one.
>John
Same response here, a little "o" on the terminal screen. I don't see the difference.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only