General information
Category:
Reports & Report designer
If I understood correctly, you have a repeated procedure that rewrite maptemp.bmp file and print it. It seems that before writing the file to C:\temp\maptemp.bmp you should wait until printing/spooling is done.
>>>>>>>>>>>>>>> your question below >>>>>>>>>>>>
I have a mapping application that can dump the contents of the screen to a BMP file. I write the file to C:\temp\maptemp.bmp. I then do an append general to a general field in a table and then print the map out on a report. This works fine for the first map report made from the application but after the first one I get write access errors and sometimes the application just hangs. I use the same file name every time to save on disk space because the files are relatively large. What could be causing this to happen?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only