General information
Category:
Source Safe Control
Title:
Best Practise Advice
Hi
I've read a lot of the previous messages on Sourcesafe and have taken on board the fact that most people reccommend avoiding integrating VSS & VFP.
However I am running into a couple of 'problems' and would appreciate some help & advice.
1.Is there any way to avoid having to have the VCT/SCT etc files in sourcesafe (without VFP integration) and then having to check out both SCX & SCT ?
2.My VFP project has a main folder and then some sub-folders i.e
\MAIN
\MAIN\FORMS
\MAIN\LIBS
working folder in VSS is set to c:\MAIN
My problem is whenever I want to check something out it defaults it to the working folder and I have to navigate to the dir I want e.g c:\main\forms. However is there anywhere I can change the setting of a particular file so that once it has been checked out once in a particular dir then that becomes its default ?
Any ideas ?
Kalim
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only