Mark,
That's certainly an alternative to what I've come up with - a command button in a container that I'm using D-and-D to simulate a BIG slider. So far the only problem is getting it to "slide" to a given point - it seems to like only certain positions, as though there was an invisible snap-to-grid in effect. Worse, these positions seem to be dependent on where on the button the cursor (finger) is when the drag starts.
Rick
>YOu could roll your own using square command buttons to act as the spinners. In the MouseDown, You could activate a timer that fires at some interval that increments or decrements the value until MouseUp.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only